How to Change A Flat Car Tire?

Knowing how to change a flat car tire is a mandatory skill for all drivers. You could end up with a flat tire just about anywhere, and you may not have access to a mechanic to get the job done. Changing a tire is not hard at all and in case you are looking for a step-by-step guide; this is your one-stop-shop. Let’s check out how you can change a flat car tire in just a few minutes.

Park Your Car

You could end up with a flat tire anywhere at all. It is important to move your car to a safe location. Try to pull over at the side of the road to avoid inconveniencing others. It is also important to keep your car on the level ground to make the tire swap easier. Once you move your car to a safe location, apply your parking brake as it helps your vehicle stay in one place. Even if your car battery is dead park your car before you jump start your car with a portable jump starter.

Keep Your Hazard Lights On

The next thing you need to do is turn on your hazard lights (flashers). Other drivers who are passing by will be able to see your car lights from a distance and steer clear of you. The lights help avoid accidents and should be turned on as soon as you realize you need to change your car tire.

Place Wheel Wedges

Once your car is parked at a safe location, place your wheel wedges to ensure your car doesn’t roll while you fix your faulty tire. If you are changing a tire on the rear side, place your wedges on the front tires. If one of your front tires are busted, place your wheel wedges at the back. If you do not carry wheel wedges, try to look for solid objects like stones or bricks to get the job done. While they might not be as effective as actual wedges, they get the job done.

Preparing Your Vehicle

Here is what you need to do ready up your car for a tire change:

  • Remove the wheel cap/hubcap
  • Use a lug wrench to loosen the lug nuts. Do not remove them completely.
  • Place a jack below the vehicle frame.
  • Slowly raise the vehicle with a jack till about six inches.
  • Remove the lug nuts.
  • Remove the flat tire

Installing A Spare Tire

Once you have removed the flat tire, bring out your spare tire and place it against the lug bolts. Slowly push the tire through the lug bolts to ensure you get the perfect fit. Do not apply too much force, no matter what. Once the spare tire is in place, tighten the lug nuts. Lower the vehicle and check the lug nuts again to see if they need to be tightened by applying your full body weight onto the lug wrench.

Make sure you always buy car parts or accessories from the reputed brand, one of the reputed brands in the jump starter market is Imazing which makes the most durable and high-quality jump starter.

Lower Your Vehicle

Once your tire has been replaced, bring your vehicle down on the ground and remove the jack. Pull the lug nuts and ensure using your wrench one final time to ensure they are in place.

Check Air Pressure

You should now check the tire pressure on your spare tire to ensure your car is safe to drive. Temporary tires are not meant to be used for long distances so you should get your busted tire repaired or get a new tire immediately.

Now you know how you can save yourself out of a tricky situation that nearly every driver faces one time or the other. The whole process should not take more than 20 to 30 minutes as long as you follow the steps carefully.

You have successfully subscribed!